Having trouble with...
Clear all

Having trouble with your Ender 3 Bed Leveling?

Member Admin
Joined: 2 years ago
Posts: 65
Topic starter  

If you are fairly new to 3D Printing then you have probably struggled with first layer problems several times. I remember when I first started, the failed prints were happening often and quite discouraging. I watched a video eventually and found some tips and tricks, but the one thing that really made a difference for my bed leveling technique was this STL file, along with the 0.30 start height. I always use the STL linked below before a major print, and it ensures my bed is level and my first layer is going to look really well.

Set your CURA Initial Layer Start Height to 0.30mm and run the profile below, fine tune your adjustment knobs until the entire print is laying down well.

Business IT Solutions -
Plastic Process Engineering

Topic Tags