Hello Guys! I am writing this new article because I just did an upgrade to one of my Ender 3’s and I wanted to share it with people who may want to try it. I was watching some videos on YouTube by CHEP (https://www.youtube.com/watch?v=Qg47Std5ywI) about how the cooling fans aren’t really doing much. I had […]
Have you just switched nozzles on your Ender 3, or maybe even a new hot-end? We have experience doing both; switching to the Micro Swiss All Metal Hot End, as well as using the hardened steel nozzles. Every time we make a change to our hot-end we disrupt the PID loop. A P.I.D Loop is
Are you on a budget but still want to install Auto Bed Leveling on your Ender 3? Well we have the same thought going on here, and anytime we can DIY a project, we do. If you have ever seen the tutorials with the sensor and an octocoupler, that is exactly what we are doing
The latest Ender 3 3D Printers are being shipped with the version 1.1.4 Motherboard, and the instructions online for flashing the bootloader have the wrong ISP pin diagrams. I have decided to write my own how-to and inform you guys how to get the ISP header pins lined up correctly with your Arduino. Tools Required
How to Flash A Bootloader and Firmware on Ender 3 Motherboard 1.1.4 Read More »
All new Ender 3 owners struggle for a little while to graps the manual bed leveling methods, even we did! It’s quite rudimentary to have to adjust some knobs and wiggle a piece of paper around, then you just have to guess how much friction is good. You also only get 4 points of leveling
