Forum

@geekafy Awesome. We have that same guide on the forums under the Ender 3'

@ferandrade Can you tell me the temperature when you turn the printer on? Does the temperature go down or up? Make sure you have the wires setup corre...

Yep, I sure have. Usually if the thermocouple comes loose or is broken this will happen. I have seen it several times. Which printer? Have you swapped...

@geekafy Are you still having trouble? I would be glad to walk you through everything; just shoot me an email I will respond faster. Justin@BizHostN...

@geekafy If you look at these files and use the compare tool you will see differences to enable the BLTouch. I always use/p>

Hello! Welcome to the forums. We sure can help. Have you verified the compatibility between the board and BLtouch 3.1? I remember reading some type of...

It's the ender 3 firmware I share on the site, already enabled for the EZABL style sensor./p>

@boddingtonsz That's from the printer's screen? I run an EZABL type sensor myself, so my firmware is a plug and play for Ender 3 on Mini E3 2.0 if y...

@boddingtonsz Any luck bud?

@boddingtonsz Pronterface or Repetier doesn't matter; I advise you to use the SD card slot if you don't have a Raspberry Pi running octoprint. Glad ...

@boddingtonsz And you are still experiencing the TMC connection error on your HMI? Are you sure it's a Ender 3 regular running the SKR Mini E3 v2.0 ...

@boddingtonsz It's relevant still, last time I had that TMC error I burned up my Z axis motor due to the incorrect settings. The relevant settings f...

You would need to try the one for the Ender 3, and enable the BLTouch stuff. I would try to make sure the printer works on basic firmware before enabl...

Hello! So, was the board working before you attached the BLTouch and now it isn't? Have you tried to disconnect the BLTouch and the machine work aga...

@knightrid Geeze sounds like a headache. I ordered my buck converters the LM2598's from eBay in a set of 10 at minimum since I use them so often. I ...